
TROUBLESHOOTING SUGGESTIONS
10
SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY
Water won’t heat
Brewer unplugged or circuit breaker
tripped
Check power supply cord
Check / reset circuit breaker
Thermostat set too low Set for desired temperature
Hi-Limit thermostat tripped
Allow to cool
Reset hi-limit (8786, 8788)
Damaged internal component or wiring
Examine wiring & connectors,
thermostat and heating element Repair/
replace as needed
Pourover - no water or too little water
added at startup
Be sure to add sufcient water, (see pg.
6 START-UP)
Coffee level low (pour-over)
Not enough water poured in Increase water amount
Too much coffee grounds Adjust amount of grounds
Coffee level too high or low
(automatic)
Timer out of adjustment Adjust timer
Brew chamber overows
Too many lter papers or wrong lter
paper
Use one (1) genuine Bloomeld lter
per brew
Brew chamber dispense hole plugged Thoroughly clean brew chamber
Too much coffee or too ne a grind Adjust coffee amount and grind
Sprays water from brew head Spray gasket improperly installed
Check/reinstall gasket on INSIDE of
brew head
Spray disk plugged Clean spray disk
No brew (automatic)
Water supply OFF Turn water supply ON
Solenoid strainer plugged Clean strainer
Water lter (if used) plugged Replace lter element
Bad BREW switch Replace switch
Damaged internal component or wiring
Examine wiring & connectors, brew
switch and solenoid, Repair/replace as
needed
No ow from hot water faucet
Faucet valve turned OFF Turn faucet valve ON
Faucet plugged Disassemble faucet, clean
Poor coffee quality
Water not hot enough Adjust water temp 195-205ºF
Keep brewer, airpots and servers clean. Install a taste and odor lter in water
supply, and replace cartridges regularly. Use a quality coffee with a consistent roast.
Use proper grind and amount of coffee per brew.
625 p/n 2M-75873 8792, 8793 Dual Coffee Brewer
625 p/n 2M-75873 8792, 8793 Dual Coffee Brewer
Comentarios a estos manuales