Bloomfield 8792 Especificaciones descargar pdf (Pagina 7)

TERMINAL

BLOCK

FRONT

PANEL

IL1717

INSTALLATION INSTRUCTIONS (continued)

NOTE: This equipment must

be installed to comply with

applicable federal, state and

local plumbing codes and

ordinances.

WARNING:

SHOCK HAZARD

Brewer must be properly

grounded to prevent possible

shock hazard. DO NOT assume

a plumbing line will provide

such a ground. Electrical shock

will cause death or serious

injury.

IMPORTANT: Do not connect

brewer to electrical power until

both tanks are lled with water.

Pour water into each pour-over

opening until water ows from

the respective brew head.

IMPORTANT:

Supply power must match

nameplate for voltage and

phase. Connecting to the

wrong voltage will damage the

brewer or result in decreased

performance. Such damage is

not covered by warranty.

NSF requires that the brewer be able to be moved for cleaning

underneath. A ex line or loops of copper tubing will satisfy this

requirement. See Figure 2 below.

In some areas, local codes require a backow preventer

(check

valve) to be installed on the inlet water line. If a backow

preventer is used, you must install a water hammer arrester

in the incoming line, between the backow preventer and the

brewer inlet, as far away from the brewer as space will allow.

This will relieve the excessive back pressures that can cause

faucet leaks and solenoid malfunctions.

ELECTRICIAN’S INSTALLATION INSTRUCTIONS

REFER TO ELECTRICAL SPECIFICATIONS - Page 1

Check the nameplate to determine correct electrical service

required for the Brewer to be installed.

IMPORTANT: Before connecting to electricity, make sure

automatic brewers are connected to the water supply.

Gourmet 1000™ dual brewers must be wired by an electrician.

Model 8792 requires a 120/240V 20A circuit (50/60 Hz, L1, L2,

Neut. plus Ground).

Remove front panel to gain access to terminal block. Green

terminal must be connected to a suitable building ground. Circuit

must be capable of 4000 Watts. See gure 3 at right.

IMPORTANT: Wiring must be installed in approved solid or

exible conduit, and must be secured to the brewer with a strain

relief (to be provided by the installer).

Fig. 3 115/230 Volt Terminal Block

Fig. 2 Water Supply Installation

COPPER LOOPS OR FLEX LINES

(PROVIDED BY PLUMBER)

NOTE DUAL 1/4”

FEMALE FLARE FITTINGS

(PROVIDED BY PLUMBER)

WATER

SUPPLY

FLOW

SOLENOID

STRAINER

WASHER

INLET

FITTINGS

SHUT-OFF VALVE

(PROVIDED BY

PLUMBER)

IL1716

WARNING

625 p/n 2M-75873 8792, 8793 Dual Coffee Brewer

1 2 3 4 5 6 7 8 9 10 11 12 ... 24 25

Comentarios a estos manuales

Sin comentarios

Bloomfield 8792 Especificaciones Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Cafeteras Bloomfield 8792