Bloomfield 1016BVM Especificaciones descargar pdf (Pagina 10)

OPERATION (continued)

ELECTRONIC FEATURES

Energizing the Brewer

When electric power is applied to the unit, all the indicators will glow

momentarily and four beeps will sound. The unit will be off.

Press the ON/OFF key. Five beeps will sound and the POWER

indicator will remain on. If the water temperature is below setpoint,

HEAT indicator will glow until water temperature reaches setpoint.

Press the ON/OFF key again to turn the brewer off. Four beeps will

sound, the tank heater and all warmers will be switched off, and all

indicator lights will go out.

Brew Settings

See pages 17 & 18 for setting Brew Time and Temperature.

ABS™ (Automatic Brew Start)

Start a brew by pressing BREW. A single beep will sound. The system

will verify that the water in the tank is at the proper temperature. If it is,

brew will start immediately. Otherwise, the BREW indicator will ash

(Brew Waiting Mode) until the water reaches setpoint temperature,

then the indicator will glow and brew will commence. If the main

warmer is off, it will be energized automatically.

At the conclusion of the brew cycle, three beeps will sound.

NOTE: To override Brew Waiting Mode, press and hold the BREW key

for 3 seconds while the BREW indicator is ashing. Brew will begin

regardless of water temperature. To avoid under-temperature brews,

this feature should only be used when setting brew volumes.

NOTE: Brew Waiting Mode (BREW indicator ashing) prevents

multiple, unattended brews. While the BREW indicator is on or

ashing, any additional strokes of the BREW key will be ignored (there

will be a beep each time the key is pressed, however). Another brew

cannot be initiated until the previous brew is complete.

The Brew Waiting Time, also called Dripout Time, (interval between

when the brew is completed and the audible signal sounds at the

end of the brew) may be adjusted between 2 and 8 minutes at the

Brew Signal Timer dial on the controller. This allows all water in brew

chamber to drip through as coffee. See page 18.

Brew Cancel

To cancel a brew in progress or a brew in waiting, press the CANCEL

key. Two beeps will sound and the BREW indicator will go out.

NOTE: If a brew in progress is cancelled, coffee will continue to ow

until all water delivered has dripped through the brew chamber.

IMPORTANT:

DO NOT energize this

brewer until the water

tank has been lled. Dry

ring will damage heating

elements. See page 6.

Fig. 6 Turning Brewer

on or off

Fig. 7 Initiate a Brew

Fig 8. Brew Cancel

912 p/n 2M-75936 Owners Manual 1016BVM Coffee Brewer

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Comentarios a estos manuales

Sin comentarios

Bloomfield 1016BVM Especificaciones Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Cafeteras Bloomfield 1016BVM