Bloomfield 1016BVM Especificaciones descargar pdf (Pagina 9)

1016BVM OPERATION (continued)

WATER HEATER

Water temperature is sensed by an electronic

water temperature probe inserted into the

water tank. This temperature signal is fed to

the controller.

The setpoint temperature is adjustable. The

controller sends a command signal to the

power board based upon a comparison

between the setpoint temperature and actual

temperature. See page 15.

The power board energizes the heating

elements based on the command signal from

the controller.

Excessive temperature will trip the hi-limit

safety switch. When the brewer cools,

remove front panel and press the red button

on the hi-limit to reset.

WATER FLOW

AUTOMATIC OPERATION

Pressing the BREW key energizes the

solenoid valve, allowing water from an

external water supply to ow into the water

tank. The incoming water forces heated

water out of the tank to perform the brew.

The solenoid uses a ow control device so

that ow is consistent between 20 p.s.i. and

90 p.s.i.

The length of time the solenoid is open

is controlled by the time setting of the

controller. See page 16.

After the solenoid closes, water will continue

to ow to the brew chamber until water level

in the tank falls below the brew pickup,

breaking the siphon.

HOT WATER FAUCET

The faucet water coil is submerged in the

hot water tank and draws heat from the brew

water. Water going to the water coil is not

controlled by the solenoid valve.

Hot water is provided at the faucet, at supply

water pressure, any time the faucet shut-off

valve is OPEN.

Fig. 5 Water Flow Diagram

Fig. 4 Heat Control Diagram

7

912 p/n 2M-75936 Owners Manual 1016BVM Coffee Brewer

912 p/n 2M-75936 Owners Manual 1016BVM Coffee Brewer

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Comentarios a estos manuales

Sin comentarios