Bloomfield 9311 Especificaciones descargar pdf (Pagina 7)

INSTALLATION INSTRUCTIONS

INSTALL LEGS

The brewer is provided with adjustable legs and rubber feet. Be

sure the legs are securely screwed into the base of the brewer, and

that the rubber feet are properly installed.

LEVEL THE UNIT

The adjustable legs allow the brewer to be leveled. Set the brewer

in its ultimate operating location and check for level with a spirit

level Adjust the brewer for level from front-to-rear, and from side-

to-side. Be sure all four feet rest rmly on the counter.

PLUMBER’S INSTALLATION INSTRUCTIONS

IMPORTANT:

This equipment must be installed in accordance with the Basic

Plumbing Code of the Building Ofcials and Code Administrators

International (BOCA), and the Food Service Sanitation Manual

of the Food and Drug Administration (FDA). Also, this equipment

installation must comply with all local plumbing codes and

ordinances.

IMPORTANT:

Brewer must be installed on a water line with a full-ow pressure

between 20 psi and 90 psi.

NOTE: If water pressure varies greatly, or exceeds 90 psi at any

time, a water pressure regulator must be installed. Plumbing

installer must supply the regulator.

Brewer must be connected to a potable water supply. Bloomeld

recommends not less than 1/4” copper tubing for installations of

12’ or less, and not less than 3/8” copper tubing for installations

exceeding 12’. Brewer must be connected to a COLD water line.

NOTE: DO NOT use a saddle tap for this water line connection.

A shut-off valve must be installed between the main water supply

and the brewer. Plumbing installer must supply the shut-off valve.

A 1/4-turn ball valve is recommended.

Bloomeld highly recommends the use of the provided water

strainer to help prevent deposits in the brewing system.

Fig. 3 Water Line Installation

Flush the water line before connecting to the brewer.

NOTE:

To enable the installer to make

a quality installation and to

minimize installation time, these

tests and suggestions should be

completed before the actual

installation is begun.

CAUTION:

UNSTABLE

EQUIPMENT HAZARD

Rubber feet must be installed

on each leg of the brewer. Legs

must be adjusted so that all four

feet rest rmly on the counter.

Failure to properly install the

feet can result in movement of

the brewer, which can cause

personal injury and/or damage

to the brewer.

CAUTION:

SHOCK HAZARD

Brewer must be properly

grounded to a reliable earth

ground to prevent possible

shock hazard. Do not assume

a plumbing line will provide

such a ground. Electrical shock

may cause serious injury.

Fig. 2 Adjustable Legs

1 2 3 4 5 6 7 8 9 10 11 12 ... 25 26

Comentarios a estos manuales

Sin comentarios

Bloomfield 9311 Especificaciones Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Cafeteras Bloomfield 9311