Bloomfield E-MAX Especificaciones descargar pdf (Pagina 20)

664 2M-Z18642 Owners Manual 2790 E-Max Dual Thermal Brewer

SERVICING INSTRUCTIONS

CAUTION -

CHEMICAL BURN

HAZARD

Deliming chemicals are caustic.

Wear appropriate protective

gloves and goggles during

this procedure. Never siphon

deliming hemicals or solutions

by mouth. This operation should

only be performed by qualied

and experienced service

personnel.

IMPORTANT:

DO NOT spill, splash or pour

water or deliming solution into

or over any internal component

other than the inside of the

water tank.

IMPORTANT:

DO NOT allow any internal

components to come into

contact with the deliming

solution. Take care to keep all

internal components dry.

NOTE: Repeat steps 4 and 7

as required to remove all

build-up.

PROCEDURE: Delime the Water Tank

PRECAUTIONS: Disconnect brewer from electric power.

Allow brewer to cool.

FREQUENCY: As required (Brewer slow to heat)

TOOLS: Deliming Solution

Protective Gloves, Goggles & Apron

Mild Detergent, Clean Soft Cloth or Sponge

Bristle Brush, Bottle Brush

Large Sink (or other appropriate work area)

1. Disconnect brewer from the electrical supply.

2. Remove the brewer top panel, then remove the tank lid

assembly. Do not disconnect the tank assembly at this

time.

3. Siphon all water from the hot water tank.

4. Mix 10 gallons of deliming solution according to the

manufacturer’s directions. Carefully pour the deliming

solution into the water tank. Lower the lid assembly back

onto the tank. Allow to sit for 30 minutes, or as directed by

the chemical manufacturer.

5. At end of soaking period, reconnect brewer to electrical

power. Install the brew chamber without lter paper or

grounds. Place an empty satellite under the brew

chamber. Force a 1-1/2 gallon brew:

a. Press the 1-1/2 gallon key

b. Press the brew key, then press and hold the brew key

until a brew is initiated.

c. Empty the satellite and repeat for the other side.

6. Disconnect brewer from electrical power and allow to cool.

7. Remove lid assembly from tank.

a. Using a stiff bristle brush, scrub internal components to

remove lime and calcium build-up.

b. Thoroughly rinse internal components of lid assembly

with clear water.

c. Store lid assembly in a safe location.

8. Using a stiff bristle brush, scrub exposed portions of the

heating element and the inside surfaces of the tank to

remove lime and calcium build-up.

9. Siphon all solution from the tank.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Comentarios a estos manuales

Sin comentarios

Bloomfield E-MAX Especificaciones Pagina 20

Comentarios a estos manuales

Relacionado con productos y manuales para Cafeteras Bloomfield E-MAX