Bloomfield E-MAX Especificaciones descargar pdf (Pagina 8)

664 2M-Z18642 Owners Manual 2790 E-Max Dual Thermal Brewer

INSTALLATION INSTRUCTIONS (continued)

IMPORTANT:

Initial set-up must be performed

by a qualied installer or

qualied service technician.

Improper set-up will damage the

brewer and void the warranty.

DO NOT CONNECT

POWER TO BREWER

WITH SATELLITES IN

PLACE.

NOTE: If “NO WATER

SENSED” error message is

displayed:

* Disconnect brewer from

electrical power.

* Review Plumber’s

Installation Instructions

* Check inlet solenoid for

debris and verify proper

operation

NOTE: Brewer will not

operate unless the appropriate

WARMER SWITCH is turned

ON.

INITIAL SET-UP INSTRUCTIONS

Plumber’s and Electrician’s installation procedures must be

completed before proceeding with the set-up.

Be sure all electrical connections are secure, and that all

plumbing connections are secure and leak-proof.

CHECK BREWER FOR PROPER CONFIGURATION

Make sure spray disk gaskets are in place INSIDE of spray

heads.

Make sure spray disks are properly installed.

Check hot water faucet for proper operation and leaks.

START BREWER OPERATION

When power is rst applied to the brewer, the display will

read “BLOOMFIELD” briey, and a “beep” will sound.

Press the POWER key. The inlet valve will energize and the

tank will begin lling. The display will read “Filling…” Fill

time for the tank is approximately 13 minutes. If water is

not sensed at the water level probe within 20 minutes, the

brewer will shut down and the display will read “NO WATER

SENSED” error message.

When tank has lled, TANK HEAT LED will glow and display

will read “Heating…”.

Slide satellites into position. Make sure satellites are

properly aligned,

Allow 30 minutes for initial water heat-up. Time will vary with

incoming water temperature. When the tank water is up to

the Precise Temperature for Brewing™, the TANK HEAT

LED will turn off.

FINAL CHECKS

After initial heat-up and before brewing, draw water from the

hot water faucet until the inlet solenoid actuates. This will

prevent volume differences to the initial brew caused by

water expansion.

Verify brew water temperature. It should be 200ºF ±5ºF.

Check and adjust water delivery volumes.

Disconnect brewer from electrical power. Inside top of the

brewer for leaks. Reassemble brewer and reconnect power.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comentarios a estos manuales

Sin comentarios

Bloomfield E-MAX Especificaciones Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Cafeteras Bloomfield E-MAX