Bloomfield E-MAX Especificaciones descargar pdf (Pagina 9)

664 2M-Z18642 Owners Manual 2790 E-Max Dual Thermal Brewer

NOTE:

If water is not sensed at the

water level sensor within 20

minutes:

Heater will be disabled

Error message NO WATER

SENSED will be displayed

Call the PHONE NUMBER

displayed for service.

GETTING STARTED

Check the brewer and satellites:

Check that the brewer is clean and the drip tray (if used)

is empty.

Check that the satellites are empty and clean with lids

properly installed.

Check the spray heads:

Remove the brew chambers. Check the spray heads. Verify

that the spray disks are clean and properly installed. Verify

that the gaskets are properly installed inside the spray heads.

Check the brew chambers:

Check that the brew chamber is clean.

Check that the wire basket is properly installed in the

brew chamber.

DAILY START-UP

Press system switch (back of brewer, lower right corner) to ON:

Brewer will “beep” and briey display the message

BLOOMFIELD.

Press POWER KEY to enter ON mode:

Brewer water tank will begin lling. The message FILLING

will be displayed.

When the tank is full, TANK HEAT LED will glow, and the

message HEATING is displayed indicating that the tank

heater is ON.

Press WARMER SWITCHES to OFF until you are ready to begin

a brew.

When the tank is lled and up to temperature, time and date are

displayed. The brewer is ready to operate.

OPERATING INSTRUCTIONS

1/2 GALLON

LEFT RIGHT

SATELLITE SATELLITETANK HEAT

POWER

START

BREW

STOP

BREW

START

BREW

STOP

BREW

1-1/2 GALLON1 GALLON 1/2 GALLON 1-1/2 GALLON1 GALLON

IL2526

Fig. 3 Control Panel

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Comentarios a estos manuales

Sin comentarios

Bloomfield E-MAX Especificaciones Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Cafeteras Bloomfield E-MAX